How to Program Remote Controls to the Alarm
Step 1: Turn "On" the ignition.
Step 2: Within 7 seconds press the Valet Switch 5 times. The alarm will chirp
the siren once to confirm entry into Remote Control Programming Mode.
Step 3: Within 10 seconds, press the “Arm” Button on each remote to be pro-
grammed. The siren will chirp to confirm each time a remote has been pro-
gramed.
If 10 seconds expire without any programming activity, or if the ignition is turned
“Off”, the system will automatically exit Remote Control Programming Mode.
The siren will emit 2 long chirps to confirm exit.
NOTE: Up to 4 remote controls can be programed to operate the alarm. When-
ever a remote control, new or existing, is programmed to the alarm, all existing
codes are erased for security. So, all remote controls which are to operate the
alarm must be programmed at the same time.
How to Program Features
To access Features Programming Mode:
Step 1: Turn the ignition "On" then "Off".
Step 2: Within 10 seconds of turning the ignition "Off", press the Valet Switch 5
times. The siren will chirp once confirming entry to Features Programming Mode.
Step 3: Within 10 seconds of entering Features Programming Mode, press the
Valet Switch the number of times equal to the number of the feature to be pro-
grammed. The siren will repeat the feature number with chirps to confirm.
Step 4: After the system acknowledges the feature to be programmed:
Press the transmitter button that corresponds to the desired setting.
Note: Once the feature to be programed is selected, you can toggle the
feature between its settings by pressing the “Arm”, “Disarm” & “••”
buttons on the remote control.
- To program more features, simply repeat Steps 3 and 4.
- If 10 seconds expire without any programming activity, or if the ignition is turned
“On”, the alarm will automatically exit Features Programming Mode. The siren
will confirm exit.
Page 7
Summary of Contents for MC-1
Page 13: ...Page 12...
