Page 10
Wiring Description
Yellow Wire - (Ignition Input): This connection is critical to the proper operation
of many of the security system's features. The Yellow wire is an ignition "on" input
to the security system.
CONNECTION: This wire must be connected to the vehicle's Ignition (also
known as Primary Ignition) wire. The proper vehicle wire will measure Positive 12
Volts when the ignition key is in the "Run" and "Start" positions and no voltage
in the "Off" and "Accessory" positions. This wire is found in the ignition switch
wiring harness.
18ga Black Wires -
These wires are used to interupt the starter wire on the
vehicle.
CONNECTION: Cut the start wire on the vehicle and attach one Black
wire to each end. This will disable the starter when the alarm is in an armed
state.
Orange Wire - (Ground when Armed Output): The Orange wire is a Ground
when Armed ouput which is active when the security system is in an armed state.
Brown Wire - (Positive Siren Output): The Brown wire is a 1 Amp Positive
output designed to operate the electronic siren for audible confirmations, and to
sound if the alarm is triggered.
SIREN CONNECTION: The Brown wire may be connected directly to the
siren's Red wire, and the siren's Black wire is connected to (-) Ground.
SIREN MOUNTING: Find a location away from the extreme heat of the engine
and manifold. A suitable location will offer a firm mounting surface, will also allow
sound dispersion out of the chosen location, and not be accessible to a thief. The
siren must not be pointed upward to avoid moisture getting inside it.
SIREN CHIRPS: The siren itself can be set for loud or less loud confirmation
chirps by refering to the Programming Features on page 8.
Brown/ Red Wire - (Parking Light/ Horn Input): This wire is provided for
selecting polarityof the Brown/White wires.
CONNECTION: The polarity of the Parking Light/ Horn Input must be deter-
mined and connected a Positive or Negative source. Determine which polarity
the vehicle uses to operate the Parking Light or Horn; this is either “Negative
polarity” or “Positive polarity”. Then, connect the Brown/Red wire to Positive or
Negative as needed. After connection of the Brown/Red wire is completed, the
next step is to connect the Brown/White wires to the parking lights or the horn
wire. The 10 amp fuse and fuse holder must be used. Failure to do so
will void all warranties.
9 Pin Connector:
Summary of Contents for MC-1
Page 13: ...Page 12...
