Page 11
Wiring Description
Brown/White Wires (2) - (Parking Light/ Horn Outputs): This is an output to
flash the vehicle's parking lights for visual arming/disarming confirmation, or
horn honk which is to attract audible attention while the system is activated.
CONNECTION: Connect these wires to the vehicle's parking light circuit,
which can usually be found at the at the headlight switch or at the light itself.
Some Motorcycles have a left and a right parking light circuit which is when both
Brown/White wires would be used to isolate each circuit. These wires can also
be connected to the horn wire usually found at the horn button.
Pink Wire - Negative Auxiliary Output: The Pink wire is an optional output
operated by the remotes “••” button.
CONNECTION: If the target wire is Positive switching, and/or draws more
than 250mA, an optional relay must be used. To configure a relay to the Pink
wire, connect it to relay pin (85), and connect a fused Constant Positive 12 Volts
to relay pin (86). Connect pin (30) to power, or ground, as needed. Pin #87 is the
output, and connected to the target wire.
Grey Wire - Valet: This Grey wire connects to the small grey wire located on
the LED/Valet switch that comes with the unit.
Red/Blue Wire - LED Status Light:
This Red/Blue wire connects to the small
Red wire on the LED/Valet switch that comes with the unit.
Blue Wire - Negative Instant Trigger: The Blue wire is a Negative instant
trigger which can be used for an optional sensor.
CONNECTION: This wire may be used with a mercury type of tilt switch or
any other optional sensor that may be desired.
Summary of Contents for MC-1
Page 13: ...Page 12...