4.11.1 Local iServer
1. An IP address should be assigned to the iServer either statically or using a DHCP
server.
2. Use a browser to access iServer’s WEB server. Simply type the iServer’s IP address
at the browser’s URL location (i.e.
http://192.168.1.200
).
3. Click on Update button.
4. Click on Configuration button and enter the password (the default password is
12345678
).
5. Click on Configuration button once again and now you’re on the configuration page.
6. Under Terminal Server section, set the Number of Connections to “
5
”.
7. Click on Save button for the changes to take place.
8. Make sure that the serial connection between the local iServer and the serial device
is valid and the serial settings like baud rate, stop bit, parity, etc. are configured
correctly.
Figure 4.26 Local iServer Configuration
Terminal Server/Remote Access (Tunneling)
50
Summary of Contents for iServer Microserver
Page 2: ......
Page 6: ...Table 4 2 List of Communication Commands 43 iv...
