4.7.4.1.9 Reading Format:
Select 2 available Format options for all Readings as following: Decimal (as default) or
Exponent to display on the Chart.
4.7.4.1.10 Number of Digit:
For users’ application and equipment requirement of a limited number of digits to be
displayed properl.
For example:
user may want to connect with remote display, which always has
hardware limitation in term of number of display digits. This feature must be use in
combination of
Decimal Point
setting because it only specifies limit the number of digits
before decimal point therefore if the measurement readings are exceeding the specified
setup
Number of Digit
, Channel A or B reading value will display “Overload”.
With the pull-down submenu, there are 10 available options from 0 to 9 to select for
users’ measurement value displayed.
4.7.4.1.11 Decimal Point:
With the pull-down submenu, there are 10 available options from 0 to 9 to select number
of decimal point.
4.7.4.2 Counting Mode:
There are two counting modes available as following:
4.7.4.2.1 Combined A-B mode:
Select from this pull-down submenu the calculation types to perform between values of 2
input signals and display the results with extra graph and digital values.
These modes require both input signals for measurement and are available as following:
+ (addition as default)
- (subtraction)
x (multiplication)
/ (division)
4.7.4.2.2 Counter Mode:
Select counting direction either UP (as default) or Down.
40
Summary of Contents for iServer Microserver
Page 2: ......
Page 6: ...Table 4 2 List of Communication Commands 43 iv...
