4.3.4 Configuration
This section describes the "Configuration" page of the iServers’s Web interface.
Click on
, the following page should appear.
When connecting your serial device to the iServer, the Serial Communications
parameters (baud rate, data bit, parity, and stop bit) must be the same on both, the
iServer and your serial device.
Figure 4.12 Configuration
Below are the definitions of terms used in the Configuration Page.
4.3.4.A Serial Communication
Baud Rate:
The serial port speed can be set from
300
to
115,200
bits/s (default is
9600
bits/s.)
Data Bit:
Options are
7
or
8
(default is
8
bits.)
Parity:
Options are
Odd, Even,
and
None
(default is None.)
Stop Bits:
Options are
1
and
2
bits (default is 1 bit.)
Flow Control:
Options are
Software Flow Control (Xon/Xoff), Hardware Flow Control
(CTS/RTS),
and
None
(default is
None
).
CONFIGURATION
CONFIGURATION
http://192.168.1.200
Address
Serial Communication
Remote Access (Tunneling)
Terminal Server
Main Menu
Save Reset
Baud Rate 9600
Data Bit 8 Bits Parity none
Stop Bits 1 bit
Flow Control none
Transciever RS-232
Modbus/TCP disable
End Char (Hex) 00 Forward End Char enable
Timeout 0
msecs
Serial Port Password disable
1234abcd
Connection Ctrl not used
Device No. 1
Connection Timeout 00100 msecs
TCP/UDP TCP
Server Type slave
Number of Connections 5
Local Port 02000
Remote Access disable Remote IP Address 0.0.0.0
Remote Port 02000
Configuration
23
A
B
C
