![background image](http://html1.mh-extra.com/html/omega/isd-th/isd-th_user-manual_4178677012.webp)
6
2.3 Parts of the iServer Unit
Figure 2.3 Parts of the iServer Unit
Table 2.1 Parts of iServer Unit
ETHERNET
RJ45 interface for 10/100BASE-T connection.
RESET
Button: Momentary (Push and Release) resets power on unit; Push and Hold for
10 seconds to reset unit to factory defaults and reset power.
100 BASE-T
LED (Green) On: Indicates 100 Mbps; LED Off: Indicates 10 Mbps.
LINK/ACT
LED (Green) On/Blinking: Indicates good network link and network activities
(receiving or sending packets).
DHCP
LED (Yellow): When DHCP is enabled, once the iServer receives the IP
parameters from the DHCP server this LED will turn Solid yellow.
RECORDING
LED (Green) Blinking
Fast
: Indicates that the unit is recording. LED Blinking:
during back-up battery operation according to sampling rate, or recording interval
if recording is ON.
°C/°F
Button: Press to change LCD display units of measurement between °C and °F.
Press and Hold along with
TIME/IP
button during power-on, this will enable
DHCP mode.
TIME/IP
Button: Press repeatedly to change LCD display from: 1) Date and Time;
2) iServer’s IP address; 3) Temperature and Humidity. Press and Hold
along with
°C/°F
button during power up, this will enable DHCP mode.
C/ F TIME/IP BKLT
RST
ETHERNET
9-12 Vdc
dc Power Input
SD Flash
Memory
Card
Standby
Button
Cover
Screw
(2 plcs)
SD Flash
Memory
Card
32 Digit LCD Display
Buttons
iServer
RJ45 interface
1
8
iServer
Reset Button
Detachable
Temp + RH
Probe
9Vdc Battery
(under cover)
iServer LEDs
Bottom Wire Entry
I/O Connectors
Removable Plug
Connector for
Input and Outputs
(under cover)
1
6
1
4
TOP VIEW
+
-
100 BASE-T
LINK/ACT
DHCP
RECORDING
STBY
The 9V battery is the
back-up power for the
recording function only.
Warning:
The standard
right angle
probe is ESD
Sensitive