![background image](http://html1.mh-extra.com/html/omega/isd-th/isd-th_user-manual_4178677047.webp)
41
4.4.7.2 Defaults
Clicking on this button will put the iServer back to its default settings.
Figure 4.28 System: Defaults
4.4.7.3 Upgrade
Figure 4.29 System: Upgrade
Upgrade –
This option loads a new firmware into the iServer over the network. The
firmware is a binary file with
.bin
extension. This file must be kept on the same PC from
which the iServer is accessed.
Once the firmware upload is completed the iServer will power reset itself. This typically
takes about 30 seconds.
When doing firmware upgrade on the iServer, there should be NO other on-
going or new Web server (HTTP) connections made to the device; otherwise,
the iServer will not upgrade the firmware. You can do either of the following to
prevent this from happening:
1. Connect the iServer directly to the PC using a straight or crossed Ethernet cable. This
will also help to have a faster firmware upload.
2. From the “Network” menu, change the Web Server Port, for example, to 500 (default
is 80), save the change, and reset the power on your iServer. The next time you will
access the iServer’s Web server, you must type
http://192.168.1.200:500
where
192.168.1.200
is the IP address of the iServer and
500
is the new Web server port
(HTTP port).
Either one of the above options will make you the only user on that iServer.
http://192.168.1.200
Address
Defaults
Readings
Chart
Web Link
Setup
Restore Factory Defaults
Defaults
Reboot
Download Configuration
Upgrade
Upload Configuration
Overview
Network
Configuration
Management
Security
Recording
System
Diagnostics
Log Out
http://192.168.1.200
Address
Upgrade Firmware
Readings
Chart
Web Link
Setup
Upgrade
Filename: iSD-TH*.bin
Defaults
Reboot
Download Configuration
Upgrade
Upload Configuration
Browse...
Overview
Network
Configuration
Management
Security
Recording
System
Diagnostics
Log Out
Please make sure no other clients are connected to the device.
Consult manual for complete instructions.