6. Use and maintenance manual
B01.26 - B02.40 - B02.10
San Maurizio C.se - 01/09/2021
www.omcr.it
G
The die overturning of half-die is allowed only parallel with lifting pin axis.
WARNING
3.2.3 - OVERTURNING OF HALF-DIES
ANGLE
REDUCTION FACTOR OF THE
NOMINAL CAPACITY LOAD
β
<
15°
β
>
40°
β1-β
>
15°
0.5
ASYMMETRIC SLING EXAMPLE
(β1
>
β
)
G
= Die load center
β
= Minimum rope angle from vertical
β1
= Maximum rope angle from vertical
WARNING
Failure to observe the regulations listed in these instructions can cause the load to fall.