Omcan FP-IT-0006, Instruction Manual

Page: 10 / 32

10
Installation
agreed with the customer, or in the event of particularly expensive transport, the machine is packed on a
wooden pallet, protected with cardboard and fastened with straps. The dimensions of the packing are shown
in Fig. 3.2.1. Check the integrity of the packing when you receive the machine. If the packing is damaged, sign
the transport docket, including the phrase: “Accepted with reservations...” and specifying the reason. If after
opening the packing, you notice that certain components of the machine are damaged, file a claim with the
carrier within three days from the date printed on the transport docket.
INSTALLATION SITE
IMPORTANT!
The site where you intend to install the machine must be solid and horizontal and the base must be sturdy
enough to withstand its weight safely. In addition, the machine must have ample space around it (overall
encumbrance), as shown in Fig. 2.4.1. This allows the operator greater manoeuvrability during work and will
facilitate future maintenance. Provide sufficient lighting around the machine, in order to ensure proper visibility
to the operator who is using the mixer.
INSTALLATION
Use a forklift or other similar equipment to handle the package, as the machine is supplied on a pallet
protected with cardboard.
• Remove the two straps that hold the cardboard box fastened to the pallet.
• Remove the cardboard.
• Remove the cellophane wrapped around the machine and any other packing material inside.
PACKAGING DISPOSAL
Packing components like cardboard, nylon and wood are products comparable to solid urban waste, which
makes them freely disposable. If the machine is delivered in countries where there are particular requirements
for waste disposal, dispose of the packaging in accordance with the regulations/standards in force.
HANDLING THE MACHINE
Lift the machine with a forklift of suitable capacity. Check the stability and position of the load on the forks,
especially along rough, slippery or titled surfaces. During handling, keep the load as low as possible to ensure
greater stability and visibility. Widen the forks to stabilise the grip as much as possible. At least two operators
are required to manually handle the mixer.
ELECTRICAL CONNECTION
IMPORTANT!
Check that the power supply corresponds to the value shown on the machine identification plate. All tasks on
electrical components must be carried out only by specialised personnel that is expressly authorised by the on-
site manager in charge. Connect the machine to a network with efficient earthing.
SIngle PhASe 110 VOlT-60 hz mAChIne
In this set-up, the machine is supplied with a power cable with section 3 x 1.5 mm. This cable is connected
to a single-phase three-pole plug. Fasten the cable to the single-phase power network (220V-50 Hz) with a
magneto-thermal circuit-breaker (16 Amp). For machine set-ups with different voltages, please consult the