13
Operation
solvents (non-toxic solvents and non-flammable). Adapt the guards to be used when cleaning and disinfecting
the machine based on the type of solvent. Follow the instructions of the cleaning products.
ASSEMbLING THE TANK
To assemble the tank, perform the procedure described in the previous paragraph in reverse order, paying
attention to re-assemble the tank in its correct position.
• Insert the tank “5” (Fig. 6.3.8) in the drag plate.
•
Turn the tank clockwise to lock it into place.
• Insert the blade holder “4” (Fig. 6.3.9) on the shaft.
• Tighten the lock knob of the blade holder “3” (Fig. 6.3.9).
• Lower the lid “2” (Fig. 6.3.9).
• Rotate the lid release knob “1” clockwise (Fig. 6.3.10).
DISASSEMbLING AND ADjUSTING THE bLADES
To disassemble the blade holder, proceed as follows:
• Switch off the machine, set the circuit breaker to “0” and remove the power plug
•
Unlock the lid and lift it.
• Unscrew the knob “2” (Fig. 6.4.1).
• Remove the blade holder “3” (Fig. 6.4.1).
• Using two wrenches, unscrew the ring nut “4” (Fig. 6.4.2).
•
Adjust the blades so that they are more or less level with the bottom of the tank, depending on the material
you intend to introduce in the cutter.
•
Now, clamp the blade holder and reposition it on the shaft.
• Lock the blade holder with the knob “2” (Fig. 6.4.1).
•
Rotate the shaft by hand to check that the blades do not touch the bottom of the tank. If they do, repeat the
adjustment.
Maintenance
IMPORTANT!
All maintenance and cleaning of the mixer should be performed only when the machine is stopped and with the
plug disconnected from the power supply. The area where you perform maintenance operations must always
be kept clean, dry and well-lit. Do not allow unauthorized personnel to perform operations on the machine. Do
not access articulated, sharp and uncontrolled openings of the machine with the body, limbs or fingers, and
without adequate protective equipment and guards (appropriate gloves, goggles, etc.) Do not use gasoline,
solvents or other flammable liquids as detergents: instead, use authorised commercial solvents )non-toxic and
non-flammable). Do not use compressed air to clean the machine If you absolutely must use compressed air,
protect yourself with goggles having side guards and limit the pressure to a maximum of 2 atm. (1.9 bar). Do
not use open flames for lighting when performing inspections and maintenance on the machine.
Summary of Contents for FP-IT-0006
