Omcan 46320, Instruction Manual, Page: 46 / 48

46
INSTALLATION REQUIREMENTS
AND CHECKLIST
The Dishwasher must be installed by a certified plumber.
Failing to follow the instructions below will void the warranty.
1. Check water hardness. If water hardness exceeds 7 grains per gallon, a water softener must be installed.
2.
Ensure the correct placement and leveling of the machine as per the manual (page 10).
3. The water supply hose / pipe should be flushed before the final connection (page 12).
4. The dishwasher must be connected to a hot water source with a minimum temperature of 40°Celcius /104°
Fahrenheit.
5. Adjust water pressure using the PRV to 20 PSI, while filling the machine with water.
6. Rinse and detergent containers can be adjusted at the bottom of the machine by rotating the adjustment screws on
the pumps. Adjust rinse/detergent flow to manufacturers recommendations. 2.6 ml per rotation for DETERGENT –
1.2 ml per rotation for RINSE.
*Rinse/Detergent containers must be equal or lower in height than the pumps*
7. Do not add an extension to the drain hose, drain connections must be made in the same flow with the drain pipe. Do
not install drain hose to exceed 26 inches / 65 cm above the ground (page 13).
8. If the tank temperature gauge is not inside the green zone, the installer must adjust to 80° Celsius / 176° Fahrenheit.
9. If the booster gauge is not inside the green zone, the installer must adjust to 80° Celsius / 176° Fahrenheit.
10.
If no water filtration/softener system is used, descale every 4 weeks.
Installer
Signature Below:
*Please read through owner’s manual completely for all instructions.*
Company Name:
Company Phone Number:
Installed By:
Date Installed:
Signature of Installer:
*This checklist must be returned with warranty card.*