Omcan 46320, Instruction Manual, Page: 20 / 48

20
Maintenance
Proper operation and safe use may be ensured only through the correct use of the appliance, as well as
the compliance with the operation instructions, the corresponding specifications and the care and cleaning
indications.
Depending on local water hardness, the nozzles on the upper wash piping and rinse arms should be cleaned.
Caution must be exercised to not damage the nozzles. If rinse nozzles are removed, they must be replaced
with the slot in line with the rinse arm.
ATTENTION MUST BE GIVEN TO THE CORRECT INSTALLATION OF FILTERS, WASH ARMS, AND
TEFLON BUSHINGS! REPLACE BUSHINGS IF WORN.
Clean the appliance with warm water and conventional cleaning aids. Stainless steel parts should never be
cleaned them with “steel wool” wire brush, etc, since even the lightest contacts on the surfaces with steel may
contaminate the stainless steel and cause rust formation. Use brushes made of polymer plastic or natural
bristles or thin brass wire. Always keep brush movements in line with grain in the Stainless Steel so that you
will not affect the appearance. Finally, rinse with clean water and dry thoroughly.
We remind you that corrosion (rust formation) on stainless steel surfaces is not created by itself, but rather
due to the use of improper cleaning products (e.g. whitening or particularly caustic cleaning products based on
chlorine).
Occasionally calcium sediments form on the internal walls of the wash compartment, tubing, and booster
chamber (due to mineral particles in the water), which may affect the correct operation of the appliance and
which requires removal.
USER’S MENU
1. User’s menu has two levels of parameterization. In order to enter the second level please advice
distributor’s after sales department.
2. For setting the default parameters at any time please advice distributor’s after sales department.
In order to enter the User’s Menu, shut down the machine and press hold Buttons SW1, SW3 & SW6 at the
same time for 3 sec with the hood closed. LED L6 flashes and a beeper sounds three times. Message “conf”
appears for a few seconds and the User’s Menu is activated.
Find the parameter that you wish to adjust using Buttons SW3 and SW4 for navigation inside the menu. The
corresponding parameter will be displayed on the screen.
Should you wish to increase the amount (+), press Button SW1.
Should you wish to decrease the amount (-), press Button SW2.