Omcan 46320, Instruction Manual, Page: 12 / 48

12
Installation
WATER SUPPLY CONNECTION
ATTENTION: Connection with the water supply should be made according to all applicable codes.
Machine must be connected to hot water source. Minimum income water temperature should be 40º.
A Pressure Regulator Valve must be inserted between the machine water inlet and the water source.
Water pressure during flow (not static), must be regulated to 20 PSI. During pressure regulation please
check the pressure gauge at the front of the machine.
This dishwasher intended for use with a hot water supply but will also operate (at slightly reduced hourly
capacity) with a cold water supply.
• The water supply hose/pipe should be OD 14mm x ID 10mm and terminate in a ¾” NPT fitting (not garden
hose).
• The water supply hose/pipe should be flushed before final connection.
• Minimum flow pressure is 15 PSI and maximum is 25 PSI.
• Connect hose supplied with machine to the inlet at the rear of the machine and the ¾” NPT fitting on the
water supply line.