Omcan 46320, Instruction Manual, Page: 15 / 48

15
Installation
CONTROL PANEL
This machine is equipped with peristaltic detergent and rinse aid pumps that are controlled through the PCB
board. For that reason in order to adjust the dosing of each one you have to enter the User’s Menu by following
the below steps, please bear in mind that for each second the corresponding pump captures the following
liquid quantities:
• Detergent pump: 0.83 ml/sec
• Rinse Aid pump: 0.19 ml/sec
By multiplying these quantities with the time duration (seconds) that the pump works, you can calculate the
volume of each liquid that it is used.
NOTE
To navigate in the user menu by pressing the buttons SW3 and SW4.
To increase the amount (+), press Button SW1.
To decrease the amount (-), press Button SW2.
To confirm the value changed, press Button SW5 once.
• Press hold Buttons SW1, SW3 & SW6 at the same time for 3 sec with the hood-door closed. LED L6
flashes and buzzer sounds three times. Message “conf” appears for a few seconds and the User’s Menu is
activated.
• Select dF to adjust detergent quantity during initial filling.
• Select dC to adjust detergent quantity during each washing cycle.
• Select rF to adjust rinse aid quantity during initial filling.
• Select rC to adjust rinse aid quantity during each washing cycle.
• Exit the User’s Menu hold SW 6 for 3 sec. until to hear the buzzer sounds.
PRIME THE CHEMICAL PUMPS
Each pump is priming separately. To do that follow the steps bellow.
DETERGENT PUMP PRIMING:
• Dishwasher on standby (OFF).
• Door closed.