![background image](http://html2.mh-extra.com/html/olympus/ir-500/ir-500_reference-manual_4286164232.webp)
232
If a problem arises
Ch
ap
ter 10:
O
th
ers
The camera is in shooting mode.
Set the mode dial to
q
.
P.96
The brightness of the monitor is not
adjusted properly.
Adjust the monitor’s brightness with
the “
s
” (monitor brightness
adjustment) settings of the setup menu.
P.167
The camera is connected to a TV.
If the AV cable is connected to the
camera through the cradle, the monitor
does not turn on.
—
(
The “ERASE” or “ALL ERASE” setting does not operate.
The image(s) are protected.
Set the “
0
” (protect) setting of the
image(s) to “OFF.”
P.126
(
The image does not appear on the TV screen even if the camera and TV are connected
through the cradle.
The camera’s video output signal type
is set incorrectly.
Set the correct video signal type in
accordance with the local system.
P.170
Wrong video input on the TV is
selected.
Set the TV to the video input to which
the cradle is connected.
—
(
The camera enters clock mode when set on the cradle.
The camera is set on the cradle with the
multi-swing display closed.
The camera automatically enters clock
mode when set on the cradle with the
display closed. To operate the camera
on the cradle, open the display.
—
(
The picture is too dark.
The flash was blocked by your finger.
Hold the camera correctly so that the
flash is not blocked by your finger.
P.41
Possible cause
Corrective action
Ref.
page
00E Adam .book Page 232 Tuesday, November 9, 2004 3:24 PM