olympia electronics BS-116, Operation Manual

Page: 3 / 21

1. Preface
A fully integrated fire detection system consisting of independent modules is a new idea in
the safety systems area. A group of 6 different devices can be combined with various ways in
order to realize a 16 to 64 zone fire detection systems with the capability to monitor and drive
extinguishing devices, electro valves, electromagnetic door latches and all the devices that
are needed to build even the most complicated fire detection system. The programming and
monitoring of these devices is done using a single control device. This is the only device that
must be in the control area.
2. Device types
The system consists of the following device types :
BS-116 16 zone fire detection panel
Keyboard- fire detection control and programming device
Indication device (repeater)
16 Relay device
Extinguishing device with adjustable delay
Public-address megaphone device with microphone
Type Description
BS-114
BS-115
BS-117
BS-118
BS-119
3. Configuration selections
The minimal required devices needed in order to develop a fully operational fire detection
system are a Bs116 fire detection panel and a Bs114 control and programming keyboard.
These devices are connected with 4 cables as shown in figure 1. The maximum cable length
must not exceed 500 metres.
The below figure shows the connection between BS-116 and BS-114. The same connection
is with BS-116 and BS-115, BS-117, BS-118.
To activate the terminal resistor 120Ohm the J6 jumper must be connected to both pins
inside the PCB.
All the above devices are powered by the fire alarm panel BS-116.
3 from 21
921116000
Date
File
Code
Page
921116000_09_016
13/03/2013
Jumper
J6