![background image](http://html.mh-extra.com/html/olt/ssgs812/ssgs812_assembly-manual_732286011.webp)
Optional:
Caulking seams will help
prevent moisture from entering your shed.
Caulking is included to complete Polygal
Windows only. Additional Caulking may be
required.
14.
Starting at the Rear Left Side, position
a
Solid Wall Panel
on top of plywood floor.
The Wall Panel bottom framing will sit flush
with floor framing. Wall siding will overhang
the floor.
Important:
Make sure all walls are aligned
in their upright position. If not, water may
leak into your shed. Unsure if panel is facing
up or down? check siding on window wall
panel to match alignment, or keep track of
your recently attached bottom plates.
15.
The side panels will sit flush with floor
framing in the corners, with the rear panels
sandwiched between them.
Note:
Siding will
overhang the floor by approx. 1/2”.
Outside 2x3
framing of wall
panel is flush
with outside of
floor
framing when
properly
aligned.
Left Side Wall Panel
Rear of Shed
Bottom Wall Plate
13.
Starting with
Solid Wall Panels
, carefully lay panel face down. Position and attach
Wall Plate
(1 1/2” x 2 1/2” x 45 1/2”) to bottom of studs of each wall panel with 3 - 2 1/2” screws. Position so plates
are flush with framing.
Left Side
Front
Important:
Pilot hole
ALL
2x3 Wall Studs
with 1/8” drill bit prior to screwing.
This will make it much easier to
attached together.
Pilot
Hole Plate
first.
Do Not Attach Walls To
Floor until Step 29.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 11