Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 10
50
1/4”
50
1/4”
Advice:
Prior to fastening walls and installing
rafters, take time to confirm your walls are
level, square and plumb.
Measure diagonal at top and bottom of walls
corner-to-corner. This should be approximately
50 1/4”. More importantly, if measurements are
not within 1/4”, your walls are not square.
Adjusting now will make it easier to install the
roof
.
Pilot
Hole first.
12.
To complete Wall Section
,
attach bottom wall plates to plywood floor
with
14 - 2 1/2” Screws
. Prior to securing, make sure wall panels are aligned
correctly on the floor. Refer to
Step 4.
Wall siding should overhang floor
while bottom wall plates should sit flush with floor.
Hardware
S1 - 2 1/2” Screws
x 14 total
