Outdoor Living Today www.outdoorlivingtoday.com [email protected]
Page 24
36.
Roof Gussets
are positioned on middle Rafters. Prior to attaching,
make sure walls are properly aligned. Have two helpers push walls at the
top from the outside of shed until inside to inside measurement between
front and rear plates is 91”. Use a level to square Gusset. Attach Gusset
with
4 - 2” Screws
.
Parts
Roof Gussets
(3/4” x 3 1/2” x 72”)
x 3
Hardware
2” Screws
x 12 total
91” across
37.
Attach all
Single
and
Double Rafter
Brackets
where rafters meet Top Wall Plates
inside of shed. Attach with
2 - 1 1/4” Screws
and
2 - 2” Screws
per Single Bracket and
6 - 2” Screws
per Double Bracket.
2” Screws
2” Screw
2” Screw
1 1/4” Screw
2” Screws
1 1/4” Screw
Hardware
1 1/4” Screws
x 12
total
2” Screws
x 24
total
Single Rafter Brackets
x 6
total
Double Rafter Brackets
x 4
total
Shingles and plywood
flush on middle panel.
Exploded view of upside down roof panels.
Outside Roof Panel.
38.
Identify all Roof Panels. There are 4 Outside
and 2 Middle Roof Panels. Outside Panels will
have shingles overhanging the plywood on one
side. Lift up and place an Outside Roof Panel on
Rear Rafters.
Parts (Steps 38 - 42)
Outside Roof Panels
(51” wide)
x 4
Middle Roof Panels
(45 1/2” wide)
x 2
Hardware (Steps 38 - 42)
2 1/2” Screws
x 8 total
Shingles overhang plywood
on outside panels.
