Outdoor Living Today www.outdoorlivingtoday.com [email protected]
Page 40
69.
Locate
Window Inserts
. Before installing, dab caulk in siding channel on both sides of window
opening. This will prevent water from getting in behind window. Position window in cavity and secure
with
8 - 1 1/4” Screws
. Caulk gap between siding and window at top. This requires a large amount
of caulking but is important to fill. Later, Window Trims will be installed to hide caulking. Complete
second Window Insert the same.
Parts
Window Inserts
(18 1/4” x 23”)
x 2
Hardware
1 1/4” Screws
x 16 total
Dab
caulk in siding
channel on both
sides of window.
Run
caulk in siding
gap at top.
Requires a large
amount.
67.
Place 1st
Roof Ridge Cap
on roof peak overhanging shingles by approximately 1”. Attach with
2 - 1 1/2” Shingle Nails
9” from end. Place 2nd Ridge Cap 1” back from first cap. Attach with
2 - 1
1/2” Shingle Nails
9” from end. Alternate each Ridge Cap seam as you proceed.
Parts (Steps 67- 68)
Roof Ridge Caps x 22
Hardware (Steps 67- 68)
1 1/2” Shingle Nails
x 46 total
Alternate Ride Cap seams (offsetting angle cut at peak)
Important:
Butt (thick) end
of Ridge Cap will be facing
towards the outside of shed.
9” from end
Thin End
68.
Place 3rd
Ridge Cap
8” back from 2nd (enough to cover shingle nails). Attach 3rd Ridge Cap as
per
Step 66
. Continue to position and attach Ridge Caps until half the roof is complete. From opposite
side, position and attach Ridge Caps as described above. One Ridge Cap is cut shorter to fit in the
center of the roof. Attach center cap with
4 - 1 1/2” Shingle Nails
.
8
”
8
”
