Outdoor Living Today www.outdoorlivingtoday.com [email protected]
Page 46
Rafter/Facia Nailing Plate
Side Angle
Cut Facia
E21.
Do a dry run first before securing. Position Front Facia up underneath roof panel and against
rafter ends. Have your helper hold in position. Place angle cut Side Facia underneath roof panel
against Rafter/Facia Nailing Plate. Align so Front Facia caps Side Facia and then attach the front
with
6 - 1 1/2” Finishing Nails.
Attach side with
5 - 1 1/2” Nails
securing them into the nailing
plate (closer to the top of the side facia board). Attach next piece of Front Facia.
Note:
With Front
Facia correctly aligned at corners, a small gap may occur at center seam. This will be covered by
Facia Detail Plate in
Step E23.
Small gap
may occur.
E20.
Locate and identify all Facia pieces:
Front & Rear Facia (4)
(1/2” x 4” x 50 1/2”).
Side Angle Cut Facia (2)
(1/2” x 4” x 54 1/8”). In front corner
,
align side and front Facia together
.
Front facia will cap side facia
.
Front
Facia
Front caps
side facia.
E19.
Place second Door into position and attach as per
Step E17
. Make sure Doors can open and
shut correctly prior to completely securing all hinge screws.
