Olivetti Fax-Lab S95, Instructions Manual

Page: 15 / 56

XI
Once the print head has been inserted , the operator
console closed and the handset replaced , the fax ma-
chine starts the nozzle cleaning and checking procedure ,
which is completed by:
• the
printing , on the sheet loaded automatically, of a diag-
nostic test sheet containing:
-
a numbered scale , for checking the flow of ink and the
electrical circuits of the print head nozzles.
- a group of graphics and text , so that the printing qual-
ity may be evaluated.
• the display shows the message: "CHECK PRINT OUT",
"1 = EXIT 0 = REPEAT".
Examine the print test sheet as follows:
1. Check that the numbered scale is not broken at any point
and that the black areas do not present any horizontal
white lines : if these conditions, which confirm that the print
head has been inserted correctly and is working properly,
are respected, set the value
1 . The fax machine returns
to its
initial stand-by mode
and is ready for use. The display shows
the message:
AUTOMATIC
25-03-04 11:23
C
D
E
2. On the other hand, if there are any breaks or white lines
present, set 0 to clean the nozzles again: if the new print test
continues to be unsatisfactory, repeat the procedure another
time. At this point:
• if the printing quality still does not meet your expectations,
clean the electrical contacts and the nozzles as indicated in
the "
To clean the electrical contacts of the print head "
section of the " Maintenance operations " chapter.
• if the printing quality is satisfactory, set the value 1 . The
fax machine returns to its initial stand-by mode and is
ready for use.
IMPORTANT
When the print head is about to run out of ink, the display
shows:
INK LOW
When there is no ink left, the display shows:
OUT OF INK
To replace the print head, see the section " Maintenance op-
erations ".
To buy new print heads , see the corresponding code at
the end of the manual .
H
OW TO GET STARTED QUICKLY
IMPORTANT
Once the print head provided with the machine is
worn, remember
only to use original print heads
(see code printed at the end of the manual) .
If, after the print head has been installed, the "CHECK
PRINT HEAD" message appears again, try remov-
ing it and then reinserting it, pressing it more firmly into
position. If the message remains on the display, re-
move the print head and clean the electrical contacts
of the print head and the carriage, see "
To clean the
electrical contacts of the print head ", section
" Maintenance operations ".