Oliver LEGACY ELITE II 2023, Owner'S Manual

Page: 63 / 106

63
PLUMBING
3. Connect a known good water source to City Water Inlet and allow water to flow out all
faucets.
4. Open the freshwater tank drain valve to drain any antifreeze that may be in the tank.
5. Connect known good water source to Freshwater Inlet and open water source running
for a few minutes to flush freshwater fill line and tank.
6. Configure for water valves for boondocking so solution goes into the tank.
7. Place the end of the hose into a container of the bleach solution and into your
plumbing system using a winterization inlet.
8. Turn on the water pump from inside.
9. Let it run until the entire bleach solution has been pulled out of the container and into
the camper.
10. Continue filling the freshwater tank, until it overflows on the curbside of the camper,
using the known good water source still connected to the freshwater inlet.
11. Allow the water and bleach solution to sit inside the water lines and water tank for
about 3 hours.
12. Turn the freshwater tank drain valve to allow the water and bleach mixture to drain.
13. Once drained, close the valve and repeat steps 9 & 11 with fresh water only
14. Connect known good water source to City Water Inlet and allow water to flow out all
faucets flushing out bleach solution in plumbing lines.
15. Once again drain the freshwater tank and it is ready for use. Be sure to reset the water
pump valves back to normal mode when you are ready to use the camper.
SANITIZATION
Regardless if you winterize your camper, just drain the water for storage, or use the
system year round; at some point you will want to sanitize the fresh water system.
This may sound tedious but with your Oliver Travel Trailer you can simply use the rear
water inlet at the rear of the camper and let it do most of the work for you. Watch the
Sanitization video on YouTube.
NOTE: If you did winterize your camper, you will want to de-winterize prior to sanitizing
the system. Please see De-Winterization for details on how to de-winterize.
Sanitization can be done at any time but is most often done after pro-longed storage or
pro-longed use.
USING BLEACH TO SANITIZE FRESH WATER SYSTEM
⚠ WARNING
DO NOT RUN BLEACH SOLUTION THROUGH THE WATER
HEATER. YOU MUST BYPASS THE WATER HEATER USING
THE BYPASS VALVE.
1. Prepare a ½ cup of bleach mixed with one gallon of water and place near the rear
water inlet.
2. Connect a short piece of water hose, approximately 2 feet long to the port and in the
gallon jug of bleach solution.