Oliver LEGACY ELITE II 2023, Owner'S Manual

Page: 42 / 106

42
ELECTRICAL
LITHIUM BATTERY STORAGE PROCEDURE
Storing your lithium batteries at the correct specifications is important as it keeps the
battery in the healthiest state possible for the fastest deployment when needed.
See the manufactuer’s manual for proper lithium battery storage procedures.
CIRCUIT BREAKERS
The 120-volt system is protected by circuit breakers in the AC panel, located under the left
front dinette seat, which automatically shuts the circuit off if the circuit load is too heavy
or a short circuit occurs. If a circuit breaker has been tripped, do not reset the breaker
until the cause of the problem is identified and corrected. Verify that the 120-volt GFCI
outlet under the dinette is not tripped. In the event the outlet is tripped, it has to be reset
by pushing the “reset” button on the 120-volt outlet.
NOTICE GFCI IS ONLY ENERGIZED WHEN AC POWER IS PRESENT.
2023 120V Panel, Standard Configuration
120V BREAKER DESCRIPTIONS
MAIN — 30 AMP
Cir. #1 FRIDGE / WATER HEATER 20 AMP*
Cir. #2 RECEPTACLES 15 AMP
Cir. #3 MICROWAVE RECEPTACLE 15 AMP
Cir. #4 AIR CONDITIONER 15 AMP**
Cir. #5 CHARGER 15 AMP
*If equipped with 12v Truma water
heater option, refrigerator will be alone
on this circuit which will be protected by
a 15 amp breaker
**Circuit will be protected by a 20 amp
breaker when equipped with Truma A/C
option
Rev. 10/2022
2023 Elite II – Other 12V Breakers & Fuses
BUSBAR CONNECTIONS & ADDITIONAL
FUSING/BREAKERING INFO.
STUD A
1
EXTERIOR SOLAR PORT 15 AMP (ATC FUSE)
2
SOLAR SHUNT POWER 1 AMP (SLOW BLOW)
3
SOLAR
50 AMP
(TYPE 2 BREAKER)
4
DC FUSE PANEL
60 AMP
(TYPE 3 BREAKER)
STUD B
1
INVERTER CHARGER
200 AMP / 300 AMP
(TYPE 3 BREAKER)
2
12V TOW VEHICLE CHARGE
20 AMP
(TYPE 3 BREAKER)*
STUD C
1
ELECTRIC BLADE VALVE 1/2 AMP (SLOW BLOW)
2 CO/LP DETECTOR POWER 1 AMP (ATC FUSE)
3
COMPOSTING TOILET POWER 2 AMP (GLASS FUSE)
4
ELECTRIC JACKS 30 AMP (SLOW BLOW)
*Breaker not installed when travel trailer is equipped
with lithium batteries