Oliver LEGACY ELITE II 2023, Owner'S Manual

Page: 60 / 106

60
3. Next, you will need to close the by-pass valve on your Suburban or Truma water
heater.
4. You can access the water heater by-pass valve through the curbside access panel
below the bedding.
5. The bypass valve will be located near the back of the water heater.
6. Turn the bypass valve so the handle points toward the rear of the travel trailer.
7. Next, you will need to configure the water pump valves, which will allow you to pump
RV antifreeze into the plumbing system from the inlet at the rear of the travel trailer.
8. You will find the pump and valves inside the camper under the curbside bed or
seating area.
9. Configure the valves for winterization. See valve configuration diagrams.
10. Next, attach a hose approximately 2 feet in length to the winterization inlet located at
the curbside rear of the travel trailer.
Rear Water Inlet located to
the right of the rear bumper
11. Place the end of the hose into a gallon jug of non-toxic RV antifreeze. DO NOT dilute
the antifreeze before pumping it into your plumbing system. It is important that you
use only concentrated RV antifreeze for winterization.
NOTE: You will need about 3 gallons of RV antifreeze!
12. Now, go inside the travel trailer and turn on the water pump.
13. Turn on the cold water at the kitchen faucet and let it run until the flow turns from
water to antifreeze and turn it off. Repeat this step for the hot water as well.
14. In the bathroom, turn on the cold water at the vanity sink until the flow turns from
water to antifreeze and turn it off. Repeat this step for the hot water as well.
15. Next, open the lid on the toilet and press the flush lever until the flow turns from
water to antifreeze.
16. Ensure some antifreeze remains in the bowl to keep the seal lubricated.
17. Next, at the outside wash station located at the rear street side of the trailer, turn on
the cold water and let it run until the flow turns from water to antifreeze.
18. Turn off the cold water and repeat the same steps with the hot water as well.
19. Then, go inside the travel trailer and turn off the water pump.
20. Next, connect an antifreeze hand pump to the city water inlet on the street side, rear
of the travel trailer and insert the other end into a gallon of RV antifreeze.
PLUMBING