Oliver LEGACY ELITE II 2023, Owner'S Manual

Page: 41 / 106

41
ELECTRICAL
130 AH LITHIUM BATTERIES PROPER RESTART
If the inverter is OFF, drained or has entered Low Battery Cut Off (LBCO) and any or all
of the batteries are OFF (no LED light on battery), you must properly restart/reboot the
system to avoid damaging the internal Battery Management System (BMS). See our
video on YouTube.
The following procedure should be followed to Reboot/Restart:
REBOOT/RESTART SEQUENCE
1. Ensure that the inverter is turned OFF.
2. Under the street side bed access panel, switch the inverter circuit breaker to the OFF
position. Press the red button.
NOTE : This will cause a communication issue for the inverter remote display and requires
a proper restart sequence to ensure proper communication between the inverter and
remote display. (Error 20)
3. Turn all batteries ON
4. Switch inverter circuit breaker to the ON position. Press the leg back into position.
5. Turn the inverter ON at the inverter.
6. Verify communication software has loaded.
NOTE : Press the Up/Battery Button to scroll through.
7. Turn the inverter OFF at the inverter.
8. Turn the inverter remote display ON.
320 AH LITHIUM BATTERIES
(OPTIONAL EQUIPMENT)
For operating instructions and troubleshooting, view the manufacturer’s manual.
The 320 AH lithium battery has a built-in heating system and does not require a separate
heat mat. When charging is required and temperatures are below freezing the built-in
BMS will automatically heat the internal temperature of the battery so that it charges
properly.
LEGACY ELITE II 12-VOLT LITHIUM BATTERY CONFIGURATION
(TWO BATTERIES)
59
ELECTRICAL
LEGACY ELITE II
(TWO BATTERIES)
LITHIUM BATTERY CONFIGURATION
(4/0 Black Cable)
(4/0 Red Cable)
Note:
Battery Jumpers are 4/0
Rev. 11/06/2020
Compliancy Note:
No more than four terminals allowed per stud. (ANSI/RVIA LV 6-1.14)
Primary Ground
Primary Hot
59
ELECTRICAL
LEGACY ELITE II
(TWO BATTERIES)
LITHIUM BATTERY CONFIGURATION
(4/0 Black Cable)
(4/0 Red Cable)
Note:
Battery Jumpers are 4/0
Rev. 11/06/2020
Compliancy Note: No more than four terminals allowed per stud. (ANSI/RVIA LV 6-1.14)
Primary Ground
Primary Hot