Oliver LEGACY ELITE II 2023, Owner'S Manual

Page: 52 / 106

52
PLUMBING
NOTICE • IF YOU NOTICE WATER LEAKING UNDER THE CAMPER
YOU MAY NEED TO CLOSE THE FRESH TANK DRAIN
VALVE.
• ALWAYS FILL THE TANK WITH CLEAN WATER FROM
A KNOWN SAFE SOURCE. MAKE SURE TO CAP THE
WATER INLET WHEN THE TANK IS FILLED. ALSO,
ALWAYS FILL THE SYSTEM WITH A HOSE THAT
YOU KNOW IS CLEAN AND IS USED ONLY FOR THIS
PURPOSE. WATER FROM TANKS IS NOT INTENDED FOR
CONSUMPTION.
DRAINING THE FRESHWATER TANK
Under the curbside bed access panel below the water pump, you will see a standard
T-valve (See Fig 1-5 on page 53) . Opening this valve allows you to drain the freshwater
tank before traveling, when winterizing, or as otherwise needed. The water will be
released below the trailer near the rear bumper. Do not forget to close the valve after
emptying the freshwater tank.
NOTICE WHEN TRYING TO DRAIN THE ENTIRE ON-BOARD
FRESHWATER SYSTEM, MAKE SURE TO OPEN FAUCETS
AND REMOVE THE WATER HEATER DRAIN PLUG. THIS
WILL EQUALIZE THE AIR PRESSURE AND ALLOW FREE
WATER FLOW. IT MAY BE NECESSARY TO RAISE THE
FRONT STABILIZING JACK SLIGHTLY TO ALLOW GRAVITY
TO HELP DRAIN THE FRESHWATER TANK.
REAR WATER INLET
The rear water inlet is located on the lower right, rear of trailer. This inlet serves multiple
purposes using the Water Pump to pull water into the freshwater tank or plumbing lines.
⚠ WARNING THE SANITIZATION AND DECALCIFICATION PROCESS
SHOULD NEVER BEEN DONE TOGETHER. MIXING VINEGAR
AND BLEACH CAN CAUSE A LETHAL TOXIC GAS!
THE REAR WATER INLET IS USED FOR:
• To fill the freshwater tank from a potable water container using the onboard water
pump when city water is not available.
• Pumping non-toxic RV antifreeze into the water lines when winterizing.
• Sanitization of the plumbing system.
• Decalcification the plumbing system.