Oliver 1808-CE, User'S Operating And Instruction Manual

Page: 27 / 63

1808-CE
1808S20035 7-6
(See step one of “Changing to a tray carrier set with the same cutoff as the previous set” on
page 7-2)
Step 4. Install the cutter assembly. CAUTION! You must install the cutter assembly so it is in time
with the tray carriers or the blade will jam on the carriers. Run the machine slowly until a gap between
tray carriers is approximately underneath the center of the cut-out in the side frame (see photo above)
Insert the cutter assembly into the frame with the blade in the gap between the tray carriers. Replace
the side plates and secure with the hex bolts.

You can remove and
install a different tray
carrier set with the
same cutter unit or a
new one with a
different cutoff

Run the tray
carriers until they
are lined up with
slot in the side
frame as shown
See Page 7of 7

Install new cutter unit with
cutter blade between the
slots in the tray carrier
Caution: The blades are
sharp
See Page 7of 8