Oliver 1808-CE, User'S Operating And Instruction Manual

Page: 21 / 63

1808-CE
1808S20009 6-1
CLEANING PROCEDURES
WARNING
DISCONNECT FROM POWER BEFORE CLEANING OR SERVICING.
CAUTION
This is not a wash-down machine! Do not directly spray any area of this machine.
Clean machine areas by using only a damp rag or damp plastic scouring pad.
Clean the Heat Seal Assembly before cleaning the Conveyor because the debris that will
be removed from the Heat Seal Assembly will fall onto the Conveyor.
Inspect the Heat Seal Roll for accumulation of debris (food Product). Clean off the
debris with a damp plastic scouring pad such as
“Scotch Brite” brand pads.
CAUTION
Always allow heated roller to cool before cleaning Heat Seal Assembly.
Do not use metallic instruments such as screwdrivers or knives to clean the Heat
Seal Roll, this will cause damage to the sealing surface. Also, do not spray the
Heat Seal Roll. Use only damp rags or towels to remove the loosened debris from
the rolls.
Tray carriers, if heavily soiled, can be removed for cleaning.
CAUTION
Only remove approximately one infeed section of the tray carriers at one time.
Removing all the tray carriers and advancing the conveyor can cause severe
damage to the machine.
Remove the infeed section of tray carriers, wash, replace, advance conveyor, and repeat
until all tray carriers have been cleaned.
Check the corner areas of the frame for accumulation of debris that may have
accumulated due to spills.
NOTE
These cleaning recommendations are not meant to replace or supercede plant
standard manufacturing procedures or regulatory requirements.
If Plant procedures call for the use of sanitizing solutions, use a rag dampened
with the sanitizing solution after cleaning is completed.