Place the support centered under the tail boom and measure at the tube ends the
same distance to the building board. So it is checked that the trough was grind
parallel to the top of the support.
Tail boom sanded before bonding in the area of the support with 400 grain
sandpaper and remove the sanding dust.
Stick the support with 5 minute epoxy to the tail
boom. The two holes in the support are in alignment
with the two holes in the tail boom. Push the fixed
front part of the rudder into the slot of the tail boom.
Vertically align the tail edge of the rudder to the tail
boom.
Stick the "Fresh" rudder with superglue into the tail
boom.
Superglue activator ist helpful in this case.
5
