Construction of vertical stabilizer (rudder)
Separate components with a sharp balsa knife from balsa and connection webs
remove from the components (little grinding).
Stuck together and stick together. Use superglue in order to save weight.
Leading edge and tip grind around. Tail edge grind tapered.
Planing in the hinge region with the balsa plane at 45 degree.
The control horn is glued with superglue after ironing the covering film.
Construction of the tail boom
Elevator support stick together of two balsa parts. Then grinding a trough according
to the 12mm tail boom diameter. If something goes wrong during grinding, don't
worry, the kit contains additional support parts.
4
