Modular Wireless I/O System – User Guide
8
5.
INSTALLATION
A.
Outdoor Enclosure Installation
1.
Install or use existing outdoor NEMA-type enclosure.
2.
Be sure the WIO® System meets applicable grounding requirements in the enclosure.
3.
Install a 35 mm x 7.5 mm DIN rail (at least 166 mm (6.5-inch) wide) inside the enclosure.
4.
Provide external power supply: 9-30 VDC.
5.
Provide antenna and antenna cable with SMA male end to connect to WIO Radio Module.
a.
There are various types of antennas including bulkhead, omni, and yagi. Please use the
appropriate type for your application.
6.
Connecting a lightning arrestor is highly recommended.
7.
Install antenna (performing a RF site survey prior to installation is highly recommended).
8.
Make a hole on the bottom of the enclosure to run wires.
9.
Run conduit for power and antenna cable.
10.
Connect antenna cable to antenna and then feed cable into enclosure.
11.
Feed power wiring into enclosure.
12.
Repeat above steps for other site location.
1: Radio (SMA Female)
2: Cable (SMA to N / Male to Male)
3: Lightning Arrestor
(N to N / Female to Female)
4: Cable (N to N / Male to Male)
5: Antenna (N Female)
❶
❷
❹
❸
❺
Summary of Contents for Wio BM-0868-RM1
