OleumTech Wio BM-0868-RM1, User Manual

Page: 5 / 43

Modular Wireless I/O System – User Guide
4
2. COMPLIANCES
Important Information to the User

This device MUST be professionally installed only by a factory representative or a trained authorized technician.

Changes or modifications not expressly approved by the manufacturer may void the user’s authority to operate
the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this
device may not cause harmful interference, and 2) this device must accept any interference received, including
interference that may cause undesired operation.

To reduce potential radio interference to other users, install and use only the antenna supplied by the
manufacturer to ensure successful communications.
FCC RF Exposure
To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained
between the antenna of this device and all persons.
FCC Interfere
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful communications to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:

Reorient or relocate the antenna.

Increase the separation between the equipment and receiver.

Consult the manufacturer for technical help.
This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC Rules. In
order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with
non-approved equipment or use of unshielded cables is likely to result in interference to radio and television reception.
The user is cautioned that changes or modifications made to the equipment without the approval of the manufacturer
could void the user’s authority to operate this equipment.