24
Note.
Only one filter can be set in the frequency selected by an
operator. Activation of other filter makes the earlier selected filter inactive
within the set frequency.
9
" " - selection of the position of complex plane center. Can be set in
the following positions:
- complex plane center,
- in the right center of
the screen,
- in the right upper corner,
- in the upper center of the
screen, - in the left upper corner, - in the left center of the screen, - in
the left bottom corner, - in the bottom center of the screen, - in the right
bottom corner,
- per-channel display when operating in double frequency
mode.
10
" Grid"– variants of marking for the complex plane: " "– square,
" " – radial, " " – Off.
11
" Axis"– activates coordinate axes.
12
" ALARM" – activation and setting of frames (threshold levels).
Types of frames:
- frames are switched off,
- circle frame type,
-
threshold frame type, - sector frame type, - cutoff frame type.
13
"SWEEP" – number of samplings displayed on time charts (see
Figure 8, pos. 4) - 256; 512; 1024; 2048; 4096; 8192; 16384, 32768
measurements.
14
"PROBE" – Connector type: "Refl", "Bridge", "Single".
15
"RPM" – rounds per minute for the eddy current rotary scanner.
Selected from the standard range: 600, 840, 1020, 1200, 1500, 1800, 2100,
2400, 2700, 3000.
16
"ROT" – type of connected rotary eddy current scanner SVR-03 or
MINI MITE.
17
"Mix type" – is selected for the frequencies mixing (setting is available
in double frequency mode), where:
"+" – summation, "–" – subtraction, "~X+" - summation with inversion in Х-
direction, "~Y+" - summation with inversion in Y-direction.
If the mix type is "+", then:
XCi=X1i*M1+X2i*M2;
YCi=Y1i*M1+Y2i*M2.
If the mix type is "-», then:
XCi=X1i*M1-X2i*M2;
YCi=Y1i*M1-Y2i*M2.
If the mix type is «~Y+», then:
XCi=X1i*M1-X2i*M2;
YCi=Y1i*M1+Y2i*M2.
If the mix type is «~X+», then:
XCi=X1i*M1+X2i*M2;
YCi=Y1i*M1-Y2i*M2.