HUB-TF_HUB-TFHB_rev042709
3
1.
Unscrew the 3 captive Retaining Screws (C) and remove the Housing Cover (A) from the Housing Base (B).
2.
Release the 4 Keyhole Screws (F) and then slide and withdraw the Camera Platform (G) from the Housing
Base (B).
3.
Mount the Camera (not included) (H) onto Platform (G) using the 1/4" UNC Screw (I) Supplied, ensuring that the
Insulation Pad (J) is mounted between the Platform and the Camera. Always check that the Camera is firmly
attached to the Platform.
4.
Connect the Camera / Heater power cable to the rear Terminal Block (E) through the first Cable Conduit (D)
referring to the circuit diagram shown in the WIRING DIAGRAM section of the manual for the terminal
designations.
5.
Connect the video cable to the Camera through the second Cable Conduit (D).
FITTING INSTRUCTIONS
(A)
(B)
(C)
(D)
(E)
(F)