Oki MC561, Maintenance Manual

Page: 148 / 276

44473001TH Rev.1
148 /
Oki Data CONFIDENTIAL
5. MAINTENANCE MENUS
5.2 Service Bit Menu
Additional Fax Setting menu
(When setup ServiceBit=ON, the following items will be displayed at Asmin Setup
→
Fax
Setup)
# Item Settings Description ODA OEL JP1
1 Service Bit ON
OFF If set OFF, some menu items are not
displayed on the panel.
It will be shown when OKIUSER set on
except for JP1, JPOEM1. OFF OFF OFF
2 Country Code U.S.A.
International
United Kingdom
Ireland
Norway
Sweden
Finland
Denmark
Germany
Hungary
Czech/Slovakia
Poland
Switzerland
Austria
Belgium
Netherlands
France
Portugal
Spain
Italy
Greece
Australia
New Zealand
Singapore
Hong Kong
Latin America
Mexico
China
Russia
Taiwan
Japan Select the country in which the
PX736MFP is going to be installed.
When the desired country code is
selected by this setting, the PTT
parameters that are
suited to the target country are set.
In this setting, any country code can be
selected regardless of the OKIUSER
setting. USA Intl Japan
# Item Settings Description ODA OEL JP1
3 Korea
Thailand
Malaysia
Jordan
Argentina
Brazil
South Africa
Belarus
Moldova
Turkey
Ukraine
4 A/R Full Print ON
OFF It only shows, when ServiceBit = ON. ON ON ON
5 Tone For
Echo (For
Transmission) Enable
Disable It only shows, when ServiceBit = ON. Disable Disable Disable
6 Tone For Echo
(For Reception) Enable
Disable It only shows, when ServiceBit = ON. Disable Disable Disable
7 Attenuator 0~15 dB Enter Attenuator.
It only shows, when ServiceBit = ON. Depends on Country Code
8 MF Attenuator 0~15 dB Enter MF (Tone) Attenuator.
It only shows, when ServiceBit = ON.
Sets the make rate of DP (10 pps)
during call.
It only shows, when ServiceBit = ON
and Tone/Pulse setting = PULSE. Depends on Country Code
9 Pulse Make
Ratio 33%
39%
40% Depends on Country Code
10 Pulse Dial Type N
10-N
N+1 Depends on Country Code
11 MF(Tone)
Duration 75, 85, 100
mseconds Enter MF (Tone) Duration.
It only shows, when ServiceBit = ON
and Tone/Pulse setting = TONE. Depends on Country Code
12 Calling Timer 1~255 second
(s) Sets the call connection wait time (TO
timer). When the setting value is "0",
the MFP runs at the initial value of
each country. When any value other
than "0" is set, the call connection wait
time (TO timer) can be selected in the
range of 1 to 255 mm.
It only shows, when ServiceBit = ON. Depends on Country Code