1 – 22
Chapter 1 Troubleshooting
FIP1.9 Paper Jam/Tray to Regi
Step Check
Yes
No
Possible causes:
150 FEEDER ASSY (PL5.1.1)
150 PAPER CASSETTE (PL2.1.50)
SENSOR REGI (PL5.1.30)
ACTUATOR B (PL5.1.17)
CHUTE ASSY FDR1 (PL5.1.3)
HVPS/MCU (PL12.1.19)
LVPS (PL12.1.5)
CHUTE ASSY FDR2 (PL7.1.21, PL20.2.2)
CLUTCH ASSY PH (PL5.1.21, PL7.1.20, PL20.2.21)
ROLL ASSY RETARD (PL2.1.2, PL4.1.2, PL20.3.2)
CLUTCH PR-REGI (PL20.2.22)
550 FEEDER OPION (PL20.2.1)
550 FEEDER ASSY (PL7.1.10)
550 PAPER CASSETTE (PL4.1.50)
1
Checking the paper size setup.
Does the paper size in use match the size setup by
GUIDE ASSY END or by the driver on the PC?
Go to step 2.
Replace the paper,
or change the
paper size setup.
2
Does Error occur when the power is turned ON?
Go to step 3.
Go to step 5.
3
Checking the paper at ACTUATOR B.
Does the paper remain at ACTUATOR B of SENSOR
REGI?
Remove the
paper, and go to
step 4.
Go to FIP1.28
SENSOR REGI.
4
Does Error occur when the power is turned ON?
Go to FIP1.28
SENSOR REGI.
Go to step 5.
5
Checking ROLL ASSY RETARD.
Is ROLL ASSY RETARD not damaged, and installed
correctly?
Check the operation of it assembled each Paper Cas-
sette.
Go to step 6.
Replace ROLL
ASSY RETARD
(RRP2.1, 4.1,
20.17)
6
Run a test print.
Does Error occur, when the test printing is performed
with the paper supplied from the Tray 1 or Tray 2?
With the Option 550 Paper Feeder is installed, does
Error occur, when the test printing is performed with the
paper supplied from the Tray 3 or Tray 4?
Check using Chapter 2 Diagnostic [TEST PATTERN
MODE MENU].
Go to step 7.
End of work
7
Checking the paper position
Remove EP CARTRIDGE.
Does the front end of paper touch Actuator B of SEN-
SOR REGI?
Go to step 8.
Go to FIP1.28
SENSOR REGI.
8
Checking a tray feeding the paper
When running a test print, is the paper supplied from
Tray 1 or Tray 2?
With tool Go to
step 9. Without
tool Go to step
10.
Go to step 11.
9
Checking CLUTCH ASSY PH for operation
Does CLUTCH ASSY PH operate normally?
Check using Chapter 2 Diagnostic [Tray1/2 Feed
Clutch Test].
Go to step 11.
Go to FIP1.39
CLUTCH ASSY
PH.
