Oki B2200, Maintenance Manual, Page: 42 / 100

Oki Data CONFIDENTIAL
43641601TH Rev.1
42 /
Values marked with an asterisk (*) are default.
Values marked with an asterisk (*) are default.
Category Item Value Functions
LED HEAD LED HEAD -16
-15
-10*
+1
+15 Sets drive time for the LED head.
STRB TIM STRB TIM 0.50*
0.54
0.42
0.46 Sets a strobe time at 600×1200 DPI in a value relative to the strobe time at
600×600 DPI.
OPT HEAD OPT HEAD ODD/EVN*
STEP3 Sets a type of LED head installed.
PRINTPOS PRINTPOS 0mm
+0.5mm
+3.5mm
-4.0mm
-0.5mm* Sets the print start position.
LENSHIFT LENSHIFT 0mm*
+0.5mm
+3.5mm
-4.0mm
-0.5mm Sets a value for image expansion correction (fine adjustment of the LSYNC
cycle).
DRUM CNT DRUM CNT T nnnnnn Indicates the Drum Count Total value. The total number of rotations of
drums used in the printer, which is counted by the engine, is displayed on
the LCD panel. It is displayed up to seven digits.
DRUM CNT DRUM CNT nnnnnn Indicates the Drum Count value. The total number of rotations of the drum
in the image drum unit in use, which is counted by the engine, is displayed
on the LCD panel.
PAGE CNT PAGE CNT nnnnnn Indicates the Page Count value. The total page count, which is counted by
the engine, is displayed on the LCD panel.
DOT CNT DOT CNT T nnnnnn Indicates the Page Dot Count value. The total number of dots after the first
installation of a new toner cartridge is displayed on the LCD panel.
DOT CNT DOT CNT nnnnnn Indicates the Page Dot Count value. The total number of dots after the last
replacement of the toner cartridge is displayed on the LCD panel.
T1 POS T1 POS 0mm*
+1mm
+7mm
-8mm
-1mm Sets a paper feed amount from the standard tray.
(Sets an amount of travel before paper stops.)
CH ADJ CH ADJ ENABLE*
DISABLE Sets whether to enable or disable a logical value for correcting the set
voltage of CH.
SB2 ADJ SB2 ADJ ENABLE*
DISABLE Sets whether to enable or disable a logical value for correcting the set
voltage of SB2.
CH VOLT CH VOLT -3
-2
-10*
+1
+2
+3 Changes the default voltage of CH. (A change takes effect regardless of the
setting, Enable or Disable, of a logical value for correcting the set voltage of
CH.)
This page intentionally left blank