78
4.1.3
Engine Maintenance Mode
Note:
This mode is used only by maintenance personnel, and it should not be released to the end
users.
(1) To enter into the engine maintenance mode, turn the power on while holding ENTER and FORM
FEED keys down.
(2) Functions of this mode are selected by the menu.
(3) The way to exit out of this mode varies depending on the settings.
(4) There are following engine maintenance modes:
a) Head drive time setting
Sets the drive time of the LED head.
b) Head width setting
Sets the width of the LED head (39 or 40 chips).
c) Printing start position setting
Sets the starting position of printing.
d) Drum count total display
The total image drum rotation count of the printer, as counted by the engine section, is
displayed on the LCD.
e) Drum count display
The total image drum rotation count, as counted by the engine section, is displayed on the LCD.
f)
Standard tray paper feeding quantity setting
Sets the amount of paper to be fed from the standard tray.
g) High Capacity Second Paper Feeder paper feeding quantity setting
Sets the amount of paper to be fed from High Capacity Second Paper Feeder.
h) High Capacity Second Paper Feeder downloading table selection
Selects the downloading table of High Capacity Second Paper Feeder.
i)
Power Envelope Feeder paper feeding quantity setting
Sets the amount of paper to be fed from Power Envelope Feeder.
j)
Power Envelope Feeder downloading table selection
Selects the downloading table of Power Envelope Feeder.
k) Engine Reset
All EEPROM areas used by the engine section are reset to factory default values.
The followings, however, are not reset:
•
Menu Level-1
•
Menu Level-2
•
Operator Panel Menu Disable/Enable
•
LED HEAD No.
•
LED HEAD WID
•
Page Print Disable/Enable
After reset, the printer returns to normal operating mode.
Note:
"Printing start position setting" is for shipping. Do not change its default value.
Detailed descriptions of these functions are porvided in Appendix D, DIAGNOSTICS TEST.
Summary of Contents for 10i
