-
18
-
5.5.2
TV
Output
(Analog
Video
/
Mono
Audio
Out)
User can connect the NVR to a device with Analog Video input
1. Press [ENTER] button entering “TV Output” menu. Default output is
“HDMI”
2. Use [UP / DOWN] button to select NTSC or PAL analog video out
3. Press [ENTER] to switch to analog video output
4.
Check video is properly display on composite video device, press [ENTER]
button again to confirm changes.
5.5.3
Power
Saving
(Turn
OFF
video
Out
put)
1. Press [ENTER] button entering “Power Saving” menu. Default is NO
POWER SAVING
2. Use [UP / DOWN / LEFT / RIGHT] button to select screen off time
3. Press [ENTER] button to confirm.
When video signal is disabled, user can press any key to enable video output
again
5.5.4
Default
Setting
This option restores factory setting.
1. Press [ENTER] button start setting. Default value is <CANCEL>
2. Use [LEFT / RIGHT] to select <Confirm>
3. Press [ENTER] button to confirm factory setting restore, or [MENU] button to
exit.
CAUTION
:
All camera will become NOT PAIRED after restoring default settings, user
must redo pairing to receive video transmission
Default
–
HDMI
output
Select
NTSC/PAL,
Press
[ENTER]
to
confirm
Default
–
NO
power
saving
Change
power
saving
time,
press
[ENTER]
to
confirm
