Ohmeda Ohio 2000 IWS Series, Operation And Maintenance Manual

Page: 68 / 80

A-10
6600-0255-000 12/20/00
Appendix
A-10
Radiant Energy Distribution
This table lists typical average radiant energy distribution across the patient bed
surface for informational purposes only.
mW/cm
2
Zone Mattress
Average Average
Model 2001 and Series 3000 units† 34 34
Series 4000 units 22 20
CI.14.001
Typical Radiant Energy Level
on the Mattress Surface
Mattress - Model 2001/Series 3000
Mattress - Series 4000
†The radiant energy level values of older models will be less than
those shown; units prior to those with HCA serial numbers had a
440 Watt heater.
Infant Zone - 15" (38 cm) wide
Thermalink Option Specifications
Hewlett Packard CMS Monitor (Vuelink)
The warmer may be connected to a Hewlett Packard CMS Monitor via a Vuelink open
interface module (HP P/N M1032A Option A05) and HP Ohmeda option cable. The
parameters passed to the HP monitor are: patient temperature, set temperature, and
heater power level; these three parameters are displayed by default on power-up. The
user can select to display any or all of these parameters. All alarms are also passed to the
monitor. See the Hewlett Packard CMS and Vuelink manuals for features and functions of
the HP system.
SpaceLabs Monitor (Flexport)
The warmer may be connected to a SpaceLabs Bedside Monitor via a Flexport (SL P/N
90444A). The parameters passed to the SpaceLabs Bedside Monitor are: patient tem-
perature, set temperature, and heater power level. All alarms are also passed to the
monitor. See the SpaceLabs Monitor and Flexport manuals for features and functions of
the SL system
Serial data
RS-232 Connector
WARNING:
w w w w w
The computer or RS-232 monitor’s user program must continuously
check the data link. The program should constantly verify connection to
the warmer controller and check for updated data.