OHAUS T71P, Service Manual

Page: 20 / 48

CHAPTER 1
GETTING STARTED
Ohaus Corporation www.ohaus.com 1-14 7000 Series T71 Indicator Service Manual
SPAN
kg
10
SPAN
lb
5
SPAN
kg
5
SPAN
lb
--C--
SPAN
lb
0
0.000
lb
SPAN
lb
DONE
SPAN
lb
--C--
1.8.2 Span Calibration
Use this calibration method to adjust the zero calibration point and span calibration point,
without affecting the linearity calibration. Be sure there is no load on the scale.
Press and hold TARE/Menu until LFT OFF flashes and CALIBRATION
appears. Press Yes . CAL ZERO appears. Press No .
CAL SPAN appears. Press Yes . SPAN and the current unit of measure
and Span calibration point flash.
Note : To change the span calibration point, press No and enter the
value using the keypad. Then press Yes .
To change the calibration unit of measure, press No to alternate
between kg and lb.
Place the specified calibration weight on the scale and press Yes .
The display shows SPAN --C-- , followed by SPAN DONE .
SPAN 0 appears. With no load on the scale, press Yes .
The display shows SPAN --C-- , followed by SPAN DONE, and returns to
the current application mode.