INSTRUCTION MANUAL
5
1.
PREPARING THE MACHINE:
1.1. Place the machine on a flat and stable surface, with enough height available so that
the sky dancer fabric can be propelled upwards without coming into contact with anything
around it.
1.2. Loosen the locking knobs (9) and position the turbine vertically as shown in Picture 1
1.3. Tighten the locking knobs (9).
1.4. Loosen and remove the fastening screws (11) of the head which is attached to the
SIROCCO machine and remove the head.
2. ATTACHING THE HEAD:
2.1. Attach the SIROCCO SKY DANCER head to the turbine as shown in Picture 2 using
the fastening screws (11).
2.2. Attach the air man or sky dancer. Generally these accessories has a Velcro strip
on the inside of the fabric, which needs to be attached to the Velcro strip (12) around
the head, making sure that it is attached properly and there are no spaces where air can
escape.
2.3. In the event that the air man or sky dancer does not have a Velcro strip, attach it
tightly using a sling.
3. ELECTRICAL CONNECTION:
3.1. Position the power supply (1) so that it is protected and covered from water and
cannot get wet.
3.2. Connect the power supply (1) to the electric current by means of the power input (2).
3.3. Make sure that the power socket is earthed.
3.4. Turn on the power supply switch (3) and check that the indicator LED (4) is on.
3.5. Connect the SIROCCO power cord (7) to the low voltage power output (5) of the
power supply.
4. OPERATION:
4.1. Turn the speed regulator and switch (8) to maximum. You can also leave it powered on
during assembly of the machine and turn on it up by means of the power supply switch (3).
4.2. Visually check that everything is working correctly at the beginning and that your air
man or sky dancer is not coming into contact with any object.
5. STOPPING AND DISASSEMBLY:
5.1. Turn the speed regulator and switch (8) to zero to turn off the motor.
5.2. Turn off the power supply (1) and disconnect the machine.
ASSEMBLY AND OPERATION