INSTRUCTION MANUAL
23
1- PREPARING THE MACHINE:
1.1. Place the machine on a flat and stable surface, with enough height available.
1.2. Loosen the locking knobs (11) and position the turbine horizontally as shown in Picture 1
1.3. Tighten the locking knobs (11).
2. ATTACHING THE HEAD:
2.1. Loosen and remove the rear grid fastening screws (14) that affix the standard rear
grid (7) of the SIROCCO machine.
2.2. Replace the standard rear grid (7) of the SIROCCO machine with the VULCANO rear
grid (8) supplied with the VULCANO head.
2.3. Reattach the rear grid fastening screws (14) to fix the VULCANO rear grid to the
SIROCCO machine.
2.4. Loosen the locking knobs (11) and position the turbine vertically as shown in Picture 1
2.5. Tighten the locking knobs (11).
2.6. Loosen and remove the fastening screws (13) of the head which is attached to the
SIROCCO machine and remove the head.
2.7. Attach the VULCANO head to the turbine as shown in Picture 1 using the fastening
screws (13).
3. ELECTRICAL CONNECTION:
3.1. Position the power supply (1) so that it is protected and covered from water and
cannot get wet.
3.2. Connect the power supply (1) to the electric current by means of the power input (2).
3.3. Make sure that the power socket is earthed.
3.4. Turn on the power supply switch (3) and check that the indicator LED (4) is on.
3.5. Connect the SIROCCO power cord (9) to the low voltage power output (5) of the
power supply.
4. OPERATION:
4.1. Insert the confetti to be used inside the head and mix it around so that it is loose. Do
not exceed the 500g of confetti.
4.2. Turn the speed regulator and switch (10) to maximum. You can also leave it on when
the machine is assembled and turn on it up using the power supply switch (3).
* Note that the SIROCCO motor has a delayed start-up (3 sec.)
ASSEMBLY AND OPERATION
2
1
1
3
5 4