INSTRUCTION MANUAL
14
3. HOSE CONNECTIONS:
3.1. Connecting the SIROCCO machine without PREMIX:
*The machine is usually connected to the network) and foam fluid separately.
*In such case you need to have a minimum water pressure of 2,7 BAR (43 PSI).
*If the water network doesn’t reach that recommended pressure, you can use a water
pump (see the FAQ section for more information).
3.1.1. Connect the inlet water tap (17) to the machine’s water connection (13).
3.1.2. With the inlet water tap (17) in “closed” position, connect a water hose to the
free socket of the inlet water tap (17) and turn on the general tap of its water point
(water network or pump).
3.1.3. The PREMIX connection (15) must be covered with a cap (16).
*The PREMIX connection is only used to work with a pump and a tank with a mixture
of water and foam fluid (premix).
3.1.4. Connect the absorption tube for foam fluid (18) to the foam fluid connection
(FLUID) (14).
3.1.5. Insert the filter at the end of the absorption tube for foam fluid (18) into the
ready-to-use foam fluid container and check that the inlet foam fluid tap (19) is fully
open.
3.2. Connecting the SIROCCO machine with PREMIX:
*The machine is fed with the final mixture (water + foam fluid) directly by means of a
pump. See the FAQ section for the specifications of the recommended pump.
3.2.1. Connect the inlet water tap (17) to the machine’s PREMIX connection (15).
3.2.2. With the inlet water tap (17) in “closed” position, connect the hose coming
from the PREMIX tank to the free socket of the inlet water tap (17) and turn on the
pump (not included).
3.2.3. The water connection (WATER) (13) and foam fluid connection (FLUID) (14)
must be covered with the stopper caps (16) supplied
4. ELECTRICAL CONNECTION:
4.1. Position the power supply (1) so that it is protected and covered from water and
cannot get wet.
4.2. Connect the power supply (1) to the electric current by means of the power input (2).
4.3. Make sure that the power socket is earthed.
4.4. Turn on the power supply switch (3) and check that the indicator LED (4) is on.
4.5. Connect the SIROCCO power cord (7) to the low voltage power output (5) of the
power supply.
5- OPERATION:
5.1. Turn the speed regulator / switch (8) to maximum.
5.2. Once the motor is at full speed, open the inlet water tap (17).
5.3. The foam generator will draw a little water and immediately after that it will start to
produce foam.
5.4. You can adjust the distance and density of the foam by adjusting the speed regulator/
switch (8) and the inlet water tap (17).