INSTRUCTION MANUAL
15
* If the machine is located in a place that makes it difficult to access in order to turn on it, you
should leave the speed regulator / switch (8) in the desired setting and turn on and turn off the
machine by means of the power supply switch (3).
In this case, you should also regulate the machine’s liquid supply using the general water tap
or the pump.
6. STOPPING AND DISASSEMBLY:
6.1. Close the water inlet water tap (17).
6.2. Turn the speed regulator / switch (8) to zero to turn off the motor or turn off the power
supply using the power supply switch (3).
6.3. Turn off the power supply (3) and disconnect the machine.
6.4. It is recommended that you clean the machine’s interior circuit after each use. To
do this, connect the inlet water tap (17) to the foam fluid connection (FLUID) (14), and let
clean water circulate for a few seconds to eliminate residual foam.
FREQUENTLY ASKED QUESTIONS
• The foam produced by the generator is not compact.
This is probably due to a lack of foam fluid. Increase the concentration of the foam fluid
and verify that you are using the proper concentration of foam fluid.
• The generator does not create foam or only does so in small quantities.
Lack of foam fluid in the machine.
If you have the machine hanging at a particular height, make sure that enough pressure
reaches it so that it can suck the foam fluid up to the height of the machine.
To facilitate the suction of the foam fluid from the machine, you can raise the foam fluid
container up to the height of the machine.
If this is not possible, you will need to feed the machine with PREMIX (water and foam
fluid) with a pump directly to the head’s PREMIX connection.
• What length of hose can I use to feed the SIROCCO FOAM GENERATOR?
It varies depending on the pressure and flow available. If you use a very long hose, the
drop in pressure and flow may lead to the machine being unable to function properly.
• What specifications of pump do I need in order to feed the SIROCCO FOAM GENERATOR?
It is recommended that you use a pump of about 1300w power and a curve similar to the
following: