User manual
Art. 55-106 M101
Rev. 0 03.2019
pag.
11
Offel s.r.l.
Via Lato di Mezzo, 32 48022 Lugo RA - Italy Tel. +39 0545/22542 [email protected]
www.offel.it
USALS (Universal Satellites Automatic Location System) - MOTOR SETTINGS:
To use DiSEqC Motors commands with the USALS system, on the SATELLITE SEARCH screen in the DiSEqC section
select USALS MOTOR (fig. 24). Keeping the EDIT button pressed for 2-3 seconds, the USER POSITION screen
appears (fig. 25). Enter the coordinates of the area where the installation will be performed, set the desired satellite
and confirm with the OK box; moving to GO and pressing the ENTER key the dish will automatically go into position.
Fig. 24
Fig. 25
SETTINGS MENU UNICABLE I & II:
You can use this menu for multiswitches or unicable LNBs (dCSS or SCR) and run the tests after changing the following
settings (fig. 26-31). First select UNICABLE (fig. 26) or UNICABLE II (fig. 27) in the DiSEqC section, go to the DOOR
section and keep the EDIT button pressed for 2-3 seconds (fig. 28).
Fig. 26
Fig. 27
Fig. 28
In the EDITOR UNICABLE screen it is possible to adjust the IF output frequencies based on the Unicable Multiswitch
or Unicable SCR LNB type that will be tested. Then you can test the signals from the SATELLITE SETTINGS menu.
Fig. 29
Fig. 30
Fig. 31
DISEQC 1.2 - MOTOR SETUP MENU:
Fig. 32
Fig. 33
In the DiSEqC section select the Diseqc
1.2 Motor option and press the ENTER
button to see the signal levels in the
SATELLITE SETTINGS menu. Here you
can see the signal levels and at the same
time manually rotate the DiSEqC 1.2
Motor in the EAST / WEST directions
with the RIGHT / LEFT keys.
During these operations the instrument's
battery could be discharged more quickly
since it consumes more than the normal
use of the instrument. It is therefore
advisable to keep the power supply
handy during this type of scan.
