OEG 4flex 100, Installation Manual

Page: 34 / 92

Rotate the second tube by 50° compared with the first tube. The arrows at the plastic
housing help to define the position (see Fig. 1). Connect the male connector of the second
tube with the female connector of the first tube (ensure that the protective foil over the
O-rings has been removed). Insert the tube axially into the already mounted tube. Rotate
the second tube in parallel with the first tube. Please ensure that the tube supporting clip is
in the correct position (see Fig. 3 on the right).
Press the upper and lower connectors into the supporting rail. Proceed as described above
with the other tubes. The last tube must be fastened to the top and bottom mounting rails
using M8 screws.
NOTE: Only the first and last tube of a panel must be bolted to the mounting rails (see Fig. 5
and Fig. 6).
Installation of
further tubes
11.1
34
Fig. 1 Fig. 2 Fig. 3
Fig. 4 Fig. 5 Fig. 6
OEG – Solar and storage technology
4flex
®
tube collectors
GB