OEG 4flex 100, Installation Manual

Page: 28 / 92

Unpack the pre-mounted flat-roof bracket. Set it up at the required angle
(30°, 35°, 40° or 45° - the angle can be changed by shortening or extending
the 2 piece supporting profile). Tighten the screws.
Repeat this procedure with a second flat-roof bracket and locate the safety brace in the
top left hole of the supporting profile and on the right in the hole above the lower screw
joint (see Fig. 5). If you choose the 45° installation, the screw of the safety brace will re-
place the screw of the supporting profile (see Fig. 6).
Fig. 1 Fig. 2 Fig. 3
28
Flat-roof mounting 8.0
Fig. 4 Fig. 5 Fig. 6
OEG – Solar and storage technology
4flex
®
tube collectors
GB